Gira Keyless In Keypad

Thanks to capacitive technology, the Gira Keyless In Keypad can be operated with a light touch of the finger – which makes entering the personal code especially convenient. When a finger comes to within 1 mm, it is detected as pressing the button. Releasing is detected at a distance of 3 mm (hysteresis behaviour). The switching hysteresis results in a precise switching feel. A fine acknowledgement tone provides feedback when the buttons are pressed.

Main applications are the opening of doors both indoors and outdoors for 1 to 6-family homes as well as in smaller, commercially used buildings. In addition, applications such as garage door control, turnstile control, barrier control as well as the control of motorised cylinder locks for front doors can all be realised.

An acoustic warning tone or, in connection with the door communication system, a tampering circuit is triggered by the unauthorised removal of the keypad unit.

Up to 255 codes can be managed with the Keyless In Keypad. Codes are permitted to contain up to 32 characters.

The characters of the keypad are evenly backlit with blue LEDs. A three-colour LED display signals the respective status when programming and during operation. In addition, an acknowledgement buzzer sounds. This buzzer can be switched off if desired.

Gira Keyless In enables keyless access to rooms and buildings. The technology is based on an electronic system. The keypad can be integrated as an individual device or into the Gira door communication system. The keypad can be installed in a standard device box and integrated in the outdoor and indoor design lines. It is available for the System 55 and TX_44 design lines. Using a 55 x 55 mm adapter plate, Keyless In products can also be integrated into the Gira F100 range.

A sealed security card is supplied with purchase of a Keyless In Keypad. If the Administrator PIN number is no longer available, the device can be reset using the Master PIN on the card.

2 zero-voltage 2-way momentary contact relay e.g. for door opener control or light scene control in combination with the KNX environment. The zero-voltage 2-way momentary contact relays have a dielectric strength of 24 V AC/DC and a current carrying capacity of 1.6 A AC/DC. The contact retention time can be set from 3 seconds to 30 seconds via button configuration. The 2-way momentary contact relays are able to control inductive loads, such as standard door openers. Any access code whatsoever can be assigned to each of the two relays.